Check your IELTS writing task 1 and essay, this is a free correction and evaluation service.
Check IELTS Writing it's free
British CouncilIDPCambridge
IELTS Writing Answer Sheet
Barcode 3
Candidate Name:
Blythe Chan
Center Number:
1
2
3
4
   
Candidate Number:
1
5
2
9
1
Module (shade one box):
Academic:
 
General Training:
Test Date:
0
D
8
D
   
1
M
2
M
   
2
Y
0
Y
2
Y
0
Y

The line graphs below show the production and demand for steel in million tons in the UK in 2010

The line graphs below show the production and demand for steel in million tons in the UK in 2010 GJe
The line graph gives information about the steel manufacture and its demand measuring in million tones, in the Great Britain in 2010. Overall, the most significant fact to emerge from the graph is that the rate of steel production was much higher than its demand over a twelve-month period, except the end of the year, December. Noteworthy, there was bigger fluctuation in demand than producing of steel over the given period. At the begging of the 2010 year, in January, the amount of produced steel stood at 4000, whereas the actual demand was half of that, 2000. Then, both number of produced steel and its needs rose accounting for 5000 and 3000 respectively. Afterwards the rate of manufacture dropped dramatically to the original figure of this year, 4000, and remained constant until about August. However, the period after steady increasing in the March until September experienced sharp fluctuations reaching a trough of less than 2000 and a high of approximately 3000. Remarkably, the amount of produced steel and its demand started to drop significantly at the same month, September, hitting a low of approximately 1000 and 0 respectively. Interestingly, the needs of steel rose dramatically to 2000 after reaching the lowest number exceeding the indicator of manufacture at the first time.
The line graph gives information about the
steel
manufacture and its
demand
measuring in
million
tones, in the Great Britain in 2010.
Overall
, the most significant fact to emerge from the graph is that the rate of
steel
production was much higher than its
demand
over a twelve-month period, except the
end
of the year, December. Noteworthy, there was bigger fluctuation in
demand
than producing of
steel
over the
given
period. At the begging of the 2010 year, in January, the amount of produced
steel
stood at 4000, whereas the actual
demand
was half of that, 2000. Then, both number of produced
steel
and its needs rose accounting for 5000 and 3000
respectively
. Afterwards the rate of manufacture dropped
dramatically
to the original figure of this year, 4000, and remained constant until about August.
However
, the period after steady increasing in the March until September experienced sharp fluctuations reaching a trough of less than 2000 and a high of approximately 3000.
Remarkably
, the amount of produced
steel
and its
demand
started
to drop
significantly
at the same month, September, hitting a low of approximately 1000 and 0
respectively
.
Interestingly
, the needs of
steel
rose
dramatically
to 2000 after reaching the lowest number exceeding the indicator of manufacture at the
first
time.
Do not write below this line
Official use only
CC
7.0
LR
6.0
GR
6.0
TA
6.5
OVERALL BAND SCORE
6.5
Barcode 1
Barcode 1

IELTS academic The line graphs below show the production and demand for steel in million tons in the UK in 2010

👍 High Quality Evaluation

Correction made by newly developed AI

✅ Check your Writing

Paste/write text, get result

⭐ Writing Ideas

Free for everyone

⚡ Comprehensive report

Analysis of your text

⌛ Instant feedback

Get report in less than a second

Recent posts